Seven emitter-side20-pin FFC connectors:140 logical pins reviewed against current native CAD.
109 channels each have exactly one supply-load assignment and one current-return assignment. At most4 series LED channels load any supply pin. No assumed equal sharing between parallel connector contacts is used.
With typical39.06mA/channel, nominal steady ON-slot currents are156.24mA maximum on a supply pin and39.06mA on a channel-return pin. This excludes switching/inrush transients and is not a worst-case bound.
Hirose FH12 base rating is0.5A; catalogue says use70% when all contacts carry current, giving0.35A reference. Nominal156.24mA uses44.64% of that reference. This is a connector reference comparison, not approval of the full cable assembly.
Cable conductor/temperature rating, actual contact resistance, insertion condition, current tolerance, temperature rise, flex damage and faults still require review/measurement.
The source current is not doubled by adding supply and return conductor currents; both carry the same circuit current.
FFC contact-side orientation,51mm candidate length and mated end dimensions remain subject to the existing incoming/assembly qualification. No PCB, current setting or firmware changed.
