MED-05 · Health Electronics
Flexible LED therapy mask controller
Wearable flexible illumination interconnects, battery power, compact control and mechanical strain relief.
Project context
A representative engineering program
Wearable flexible illumination interconnects, battery power, compact control and mechanical strain relief.
System architecture
How the electronics are organized
Wearable flexible illumination interconnects, battery power, compact control and mechanical strain relief.
Engineering risks to close
What must be resolved before release
- Protect flex interfaces from bend and pull stress.
- Manage distributed LED-current paths.
- Keep control and status indication reliable through assembly.
Validation plan
Evidence expected before production
- Flex-cycle, charging, current-balance and thermal tests.
- Control, timer, battery and connector-fault tests.
Decision-ready evidence packet
What a comparable RFQ should define
This checklist turns the technical story into reviewable inputs and release records. It describes what buyers and manufacturers should agree—not a claim that every listed record applies to every build.
Design baseline
Released schematic or block diagram, interface table, power states, critical constraints, and revision owner.
Manufacturing release
Gerber or ODB++, stack-up, centroid data, assembly drawings, approved DFM dispositions, and panel assumptions.
Material control
Released BOM revision, manufacturer part numbers, AVL or alternate rules, no-substitute lines, MSL handling, and exception approvals.
Validation record
Test method, acceptance criteria, sample or serial identity, measured result fields, and disposition. Example scope: Flex-cycle, charging, current-balance and thermal tests.
Production release
First-article status plus the agreed SPI, AOI, X-ray, ICT, FCT, programming, rework, OQA, labeling, and packing records.
Project-specific fields, retention periods, sampling rules, measured limits, and customer approvals are confirmed during RFQ and protected under the applicable confidentiality agreement.
Development and production controls
Manufacturing scope represented here
- Flexible-circuit handling.
- Wearable assembly control.
- Power-path test planning.
Technical image review
Board-level evidence
White-background views are published to make component placement, interfaces and assembly boundaries easier to inspect.
